WATER BASED VARNISH MATTE N610

- Water based matte varnish
- Αdds a sheen, protects and resists dirt retention
- Dries clear to a flexible, non-tacky, hard surface
- Increases color saturation
- Adjusts and unifies surface sheen
- Improves surface durability - ideal when shipping or exhibiting
- Protects colors from UV light damage
- Resists discoloration - yellowing and fogging - caused by humidity, heat and UV
- Depending on the substrate it allows surface moisture to pass through and breathe
- Allows for easy cleaning without fear of damaging the paint film
- Has excellent levelling properties - will not hold brush marks
- Τransparent when dry
- Flexible & non-cracking
- 400ml

It is suitable for protection of chalk paints, for painted and unpainted furniture, for art works and for all wooden, stone, ceramic and paper surfaces.

Shake the container at least 3 minutes after you hear the mixing ball. Before the first use spray it in the air for 3-4 seconds. After use, turn the aerosol upside down and press the actuator for 2-3 seconds to clean the valve. If the nozzle is blocked, replace it with a new one. Use outdoors or in a well-ventilated area such as an open garage. Optimal application at temperature: 10-25°C and humidity below 65% to ensure proper drying. Storage 05-35°C.

Tips:

- Ensure the surface is clean, dry and free of grease
- Wear protective gloves, protective clothing, eye/face protection
- Always paint in an open space in the open air
- The space should be as dust-free as possible
- Protect the surrounding area from overspray
- Test spray on a non-visible area
- Always spray with the can in a vertical position, otherwise the paint might 'spit' unevenly
- Spray surface from a distance of 25-30cm
- Apply in several thin layers, spraying in sweeping motions
- Don't go over bits you have missed, but leave to dry and then re-varnish area. Don't go back over areas you have already done, as this can cause clouding
- Don't attempt to remove once applied
- After use, clean the spray valve (turn the aerosol upside down and push the nozzle for about 5 seconds)